Using SST (150 Pin Breakout Box)
WARNING: This page is about a different car, the 2005 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Disconnect the PCM connector.
- Connect the SST (150 Pin Breakout Box) to the PCM as shown.
- Tighten the connector bolt.
Tightening torque 7.9 - 10.7 N.m (80 - 110 kgf.m, 69.5 - 95.4 ln.lbf)
- Connect the negative battery cable.
- Measure the voltage at each terminal.
- If any incorrect voltage is detected, check related systems, wiring harnesses and connectors referring to the possible malfunction in the terminal voltage list.