Key Programming Using Diagnostic Equipment
WARNING: This page is about a different car, the 2005 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- This procedure is used when a customer needs keys programmed into the system and not have 2 programmed ignition keys available. This procedure is also useful when programmed ignition key(s) have been lost or a new ignition switch assembly has been installed, and it is desired to erase key(s) from the passive anti-theft system (PATS) memory.
NOTE:
- This procedure will erase all programmed ignition keys from the vehicle memory and the vehicle will not start until two keys have been reprogrammed to the vehicle.
NOTE:
- 2 PATS encoded keys with the correct mechanical cut must be available to carry out this procedure. 1 or both of them may be the original keys.
NOTE:
- If additional keys are to be programmed, See KEY PROGRAMMING USING TWO PROGRAMMED KEYS . If the remaining keys are not available with the vehicle, instruct the customer to see the for instructions on programming the remaining keys.
- Turn the ignition from OFF to ON.
- Using the WDS. or equivalent Tester, follow the SECURITY ACCESS to obtain security access. See ANTI-THEFT SECURITY ACCESS .
- From the WDS or equivalent Tester menu, select IGNITION KEY CODE ERASE.NOTE:
- Do not select any additional commands from this menu.
- Turn the ignition OFF and disconnect the WDS or equivalent Tester.
- Insert the first encoded key into the ignition and turn the ignition to ON for 1 second.
- Insert the second encoded key into the ignition and turn the ignition to the ON position for 1 second.
- Remove the second encoded key from the ignition.
- The vehicle should now start with both ignition keys.