Clutch Switch: Testing and Inspection
CLUTCH PEDAL POSITION (CPP) SWITCH INSPECTIONNOTE: Perform the following inspection only when directed.
Continuity Inspection
1. Disconnect the negative battery cable.
2. Remove the clutch switch. (See CLUTCH PEDAL REMOVAL/INSTALLATION.)
3. Inspect for continuity between the clutch switch terminals B and D using an ohmmeter.
- If the clutch switch is okay, but the PID value is out of specification, perform the "Circuit Open/Short Inspection".
- If not as specified, replace the clutch switch. (See CLUTCH PEDAL REMOVAL/ INSTALLATION.)
Circuit Open/Short Inspection
1. Disconnect the PCM connector. (See PCM REMOVAL/INSTALLATION.)
2. Inspect the following harness for open or short circuit. (Continuity check)
Open circuit
- Clutch switch terminal B and PCM terminal 29
- Clutch switch terminal D and body GND
Short circuit
- Clutch switch terminal B and power supply
- Clutch switch terminal B and body GND