Transmission Speed Sensor: Service and Repair

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FN4A-EL]
1. Remove the battery duct and battery cover.
2. Remove the battery, battery box and battery tray.





3. Disconnect the input/turbine speed sensor connector.
4. Remove the input/turbine speed sensor.
5. Apply ATF to a new O-ring and install it on a new input/turbine speed sensor.
6. Install the input/turbine speed sensor.

Tightening torque 8 - 11 N-m (82 - 112 kgf-cm, 71 - 97 in-lbf)

7. Connect the input/turbine speed sensor connector.
8. Install the battery, battery box and battery tray.
9. Install the battery duct and battery cover.