DTC P0335: Notes

DTC P0335 [L3] CHART

DTC P0335	CKP sensor circuit problem
DETECTION CONDITION	If the PCM does not receive input voltage from the CKP sensor for 4.2 s while MAF is 2.0 g/s {0.26 lb/min.} or above , the PCM determines that the CKP sensor circuit has malfunction. Diagnostic support note This is a continuous monitor (CCM). MIL illuminates if PCM detects the above malfunction conditions during first drive cycle. FREEZE FRAME DATA is available. DTC is stored in the PCM memory.
POSSIBLE CAUSE	CKP sensor malfunction Connector or terminal malfunction CKP sensor is dirty Short to power supply in wiring harness between CKP sensor terminal A to PCM terminal 2Y Short to power supply in wiring harness between CKP sensor terminal B to PCM terminal 2Z Short to ground in wiring harness between CKP sensor terminal A to PCM terminal 2Y Short to ground in wiring harness between CKP sensor terminal B to PCM terminal 2Z Open circuit in wiring harness between CKP sensor terminal A to PCM terminal 2Y Open circuit in wiring harness between CKP sensor terminal B to PCM terminal 2Z CKP sensor pulse wheel malfunction Both CKP sensor wires are shorted each other PCM malfunction