| DETECTION CONDITION |
- Wheel speed signal from ABS HU/CM is invalid value when following conditions are met:
- Shift range in except P, N or R range (ATX)
- Neutral switch and clutch switch are OFF (MTX)
- Load is above 40%
- Engine speed is 2,000 RPM or above
- Brake switch is OFF
Diagnostic support note
- This is a continuous monitor (CCM).
- MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|