DTC P0130: Notes
WARNING: This page is about a different variant/trim than selected.
DTC P0130 DETECTION CONDITION AND POSSIBLE CAUSES
| DTC P0130 |
Front HO2S circuit problem |
| DETECTION CONDITION |
- The PCM monitors the front HO2S impedance when under the front HO2S heater control. If the impedance is more than 500 ohms, the PCM determines that there is a front HO2S circuit problem.
Diagnostic support note
- This is an intermittent monitor (HO2S).
- MIL illuminates if PCM detects above malfunction condition in two consecutive drive cycles or in one drive cycle while DTC for the same malfunction has been stored in PCM.
- PENDING CODE is available if PCM detects the above malfunction condition during first drive cycle.
- FREEZE FRAME DATA is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- Front HO2S malfunction
- Connector or terminal malfunction
- PCM malfunction
|