Continuity Inspection

WARNING: This page is about a different variant/trim than selected.

Disconnect the negative battery cable.
Remove the neutral switch. (See MANUAL TRANSAXLE REMOVAL/INSTALLATION ).
Inspect for continuity between the neutral switch terminals using a tester.
- If the neutral switch is normal, but PID value is out of specification, perform the "Circuit Open/Short Inspection".
- If not as specified, replace the neutral switch.

Specification

Fig 1: Terminals Continuity Table

Courtesy of MAZDA MOTORS CORP.

Fig 2: Identifying Neutral Switch Connector Terminals

Courtesy of MAZDA MOTORS CORP.