OBDII Drive Cycle Malfunction

DTC P1000 DETECTION CONDITION & POSSIBLE CAUSES

DTC P1000	OBD II DRIVE CYCLE MALFUNCTION
DETECTION CONDITION	P1000 indicates OBD II monitor testing not complete.
POSSIBLE CAUSE	The vehicle is new from the factory and has not yet completed an OBD II Drive Cycle The battery or the powertrain control module (PCM) has been disconnected OBD II monitor failure had occurred before completion of an OBD II Drive Cycle The PCM DTCs have been cleared with a WDS or equivalent tester as part of a service process

DTC P1000 DIAGNOSTIC PROCEDURE

DTC P1000		OBD II DRIVE CYCLE MALFUNCTION
STEP	INSPECTION		ACTION
1	Was the PCM quick test performed?	Yes	Go to next step.
1	Was the PCM quick test performed?	No	Perform PCM quick test. See PCM QUICK TEST .
2	DTC P1000: CHECK FOR OTHER DTCS This test should be used only if DTC P1000 was received in continuous memory. Ignore any DTC P1000s in KOEO or KOER. NOTE: DTC P1000 indicates that all of the OBD II monitors have not yet been successfully tested to clear DTC P1000. Are any other DTCs received with P1000?	Yes	Repair other DTCs. Go to applicable DTC Troubleshooting. See DIAGNOSTIC TROUBLE CODE (DTC) INDEX - POWERTRAIN CONTROL MODULE (PCM) .
2		No	Go to next step.
3	REQUEST TO CLEAR DTC P1000 Has the customer requested DTC P1000 be cleared from the PCM memory?	Yes	Inform customer that if the law in this state requires additional driving in order to clear DTC P1000 from the PCM memory, it must be performed before an inspection/maintenance test.
3		No	Complete an OBD drive cycle. See DRIVE CYCLES .