LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> B3000 Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 448 (Charging System) >> Generator Removal/Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Generator Removal/Installation

WARNING: This page is about a different car, the 2005 Mazda RX-8 and 2004 Mazda RX-8. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • When the battery cables are connected, touching the vehicle body with generator terminal B generates sparks. This can cause personal injury, fire, and damage to the electrical components. When removing the generator, always disconnect the negative battery cable.
  1. Remove the engine cover. (See ENGINE COVER REMOVAL/INSTALLATION .)
  2. Remove the battery cover.
  3. Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION .)
  4. Remove the front suspension tower bar. (See FRONT SUSPENSION TOWER BAR REMOVAL/INSTALLATION .)
  5. Remove the fresh air duct. (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  6. Position the drive belt out of the way. (See DRIVE BELT REPLACEMENT .)
  7. Remove in the order indicated in the table.
    Fig 1: Removing Generator Components With Torque Specifications
    G03701994Courtesy of MAZDA MOTORS CORP.
  8. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals