DTC P0442: Notes
DTC P0442 [AJ] DETECTION CONDITION AND POSSIBLE CAUSES
| DTC P0442 |
Evaporative emission control system leak detected (small leak) |
| DETECTION CONDITION |
- PCM measures the pump load current (EVAP line pressure) when the specified period has passed after EVAP system is sealed when monitoring conditions are met. If the load does not reach the reference current value within the specified period, PCM determines that the EVAP system has small leak.
MONITORING CONDITION
- IG switch OFF
- IAT: 5-35 °C {40-95 °F}
- Battery voltage: 11 V or above
- Atmospheric pressure: 72.2 kPa {542 mmHg, 21.3 inHg} or above
- Fuel tank level 15-85%
Diagnostic support note
- This is an intermittent monitor (Evaporative system).
- The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
- PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
- DIAGNOSTIC MONITORING TEST RESULTS is available
- FREEZE FRAME DATA is available.
- DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- Purge solenoid valve malfunction
- EVAP system leak detection pump malfunction
- Charcoal canister malfunction
- Catch tank malfunction
- Fuel filler cap malfunction
- Fuel tank malfunction
- Fuel pump unit poor seal
- EVAP hose damaged or loose
- EVAP pipe damaged
|