LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2006 >> MPV ES >> Repair and Diagnosis >> External Pages >> Different car >> Section 315 (Cruise Control System) >> Speed Control Switch >> Removal and Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal and Installation

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering wheel. For additional information, refer to STEERING WHEEL .
    Fig 1: Locating Air Bag
    G01899903Courtesy of MAZDA MOTORS CORP.
    WARNING:
    • When carrying a live air bag, make sure the bag and trim cover are pointed away from your body. In the unlikely event of an accidental deployment, the bag will then deploy with minimal chance of injury. Failure to follow these instructions may result in personal injury.
  2. Remove the steering wheel cover.
    Fig 2: Removing Steering Wheel Frame
    G01899904Courtesy of MAZDA MOTORS CORP.
  3. Remove the steering wheel frame.
    1. Remove the nuts.
    2. Disconnect the ground wire.
    3. Remove the steering wheel frame.
      Fig 3: Disconnecting Cruise Control Switches Electrical Connector
      G01899905Courtesy of MAZDA MOTORS CORP.
  4. Disconnect the cruise control switches electrical connector.
    Fig 4: Removing Cruise Control Switches
    G01899906Courtesy of MAZDA MOTORS CORP.
  5. Remove the cruise control switches.
    1. Remove the screws.
    2. Remove the cruise control switches.
  6. To install, reverse the removal procedure.