DTC C1306 [Dynamic Stability Control]: Notes

NOTE:

The initialization value of the steering angle sensor is stored using the battery power supply. Therefore, the battery power supply of the steering angle sensor is cut and the stored initialization value is cleared when any of the following items are performed. DTC C1306 is stored in the memory.
- Negative battery cable disconnection
- Steering angle sensor connector disconnection
- Fuse (ROOM 15A) removal
- Wiring harness disconnection between battery and steering angle sensor connector

DTC C1306 POSSIBLE CAUSE

DTC C1306	Steering angle sensor (abnormal initialization) system
DETECTION CONDITION	The steering angle sensor detects that the initialization procedure has not been performed.
POSSIBLE CAUSE	The initialization procedure for the steering angle sensor has not been performed. Steering angle sensor malfunction The negative battery cable connector was disconnected previously. The steering angle sensor connector was disconnected previously. The fuse (ROOM 15A) was removed previously.