Specifications Index
MX-5 MIATA SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | HEATER, VENTILATION & AIR CONDITIONING (HVAC) -- TECHNICAL DATA | ||
| Torque | See Torque Specifications in appropriate graphics under BASIC SYSTEM . | ||
| Axle Nut/Hub Nut (Front) | 174-235 Ft. Lbs. (236-318 N.m) | ||
| Battery | BATTERY INSPECTION [LF] | ||
| Brakes | |||
| Bleeding Sequence | AIR BLEEDING | ||
| Disc Brakes | BRAKES TECHNICAL DATA | ||
| Torque | See Torque Specifications in text and appropriate graphics under CONVENTIONAL BRAKE SYSTEM . | ||
| Charging | |||
| Generator | GENERATOR | ||
| Torque | See Torque Specifications in appropriate graphics under GENERATOR DISASSEMBLY/ASSEMBLY [LF] , | ||
| Drive Belts | |||
| Adjustment | DRIVE BELT INSPECTION [LF] | ||
| Belt Routing | See appropriate graphics under DRIVE BELT INSPECTION [LF] . | ||
| Engine Cooling | |||
| General Service Specifications | ENGINE TECHNICAL DATA [LF] | ||
| Radiator Cap Pressure | 17.8 psi | ||
| Thermostat R & I | THERMOSTAT REMOVAL/INSTALLATION [LF] | ||
| Water Pump R & I | WATER PUMP REMOVAL/INSTALLATION [LF] | ||
| Engine Mechanical | |||
| 2.0L 4-Cyl. | |||
| Compression | COMPRESSION INSPECTION [LF] | ||
| Oil Pressure | 49.0-85.8 psi (337-591 kPa; 3.44-6.03 kg/cm2 ) at 3,000 RPM. | ||
| Overhaul | ENGINE TECHNICAL DATA [LF] | ||
| Torque | See Torque Specifications in text under MECHANICAL - OVERHAUL - 2.0L (LF) & 2.3L (L3) | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 71-76 Ft. Lbs. (96-103 N.m) | ||
| Fuel System | |||
| Pressure Specification | 50.8-59.4 psi (350-410 kPa; 3.57-4.18 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | FUEL LINE PRESSURE INSPECTION [LF] | ||
| Fuel Filter Location and R & I | Fuel filter is attached to fuel pump assembly. See FUEL PUMP UNIT REMOVAL/INSTALLATION [LF] | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | RESISTANCE SPECIFICATIONS | ||
| Ignition Wires (Routing) | The 2.0L uses coil-on-plug ignition. | ||
| Spark Plug | |||
| 2.0L 4-Cyl. (NGK L3G2 18 110, L3Y1 18 110) | |||
| Gap | 0.050-0.053 in. (1.25-1.35 mm) | ||
| Torque | 8-10 Ft. Lbs. (10-14 N.m) | ||
| Starting | |||
| Starter | ON-VEHICLE INSPECTION | ||
| Torque | See Torque Specifications in appropriate graphics under STARTING SYSTEM | ||
| Wheel Alignment | |||
| Adjustment Specifications | |||
| Front | FRONT WHEEL ALIGNMENT | ||
| Rear | REAR WHEEL ALIGNMENT | ||
| Torque | |||
| Front | See Torque Specifications in text under FRONT WHEEL ALIGNMENT . | ||
| rear | See Torque Specifications in text and appropriate graphics under REAR WHEEL ALIGNMENT . | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 65.6-86.3 Ft. Lbs. (89-117 N.m) | ||