LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 3 Mazdaspeed, 2.3 L >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control >> Brake Fluid Pressure Sensor Initialization Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Brake Fluid Pressure Sensor Initialization Procedure

WARNING:
  • If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM, make sure to perform the initialization procedure to insure proper DSC operation.
  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2.
  3. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Chassis".
      2. Select "ABS/DSC".
      3. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "Module Tests".
      2. Select "ABS".
      3. Select "DataLogger".
      4. Select "MCYL_S_CAL".
  4. Perform the initialization procedure according to the directions on the screen.
  5. Drive the vehicle.
  6. After 5 min or more  of driving, verify that the DSC system is normal.
    Fig 1: Identifying DLC-2 Connector
    G04955736Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals