Resistance Inspection

NOTE:

Before performing the following inspection, make sure to follow the procedure as indicated in the troubleshooting flowchart. (See HOW TO USE THIS MANUAL .)

Measure the resistance between the MAF/IAT sensor terminals D and E using a tester.

If not as specified, replace the MAF/IAT sensor. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION .)
If the MAF/IAT sensor is normal, but the PID is out of specification, perform the "CIRCUIT OPEN/SHORT INSPECTION ".

AMBIENT TEMPERATURE AND RESISTANCE SPECIFICATION

Ambient temperature (°C {°F})	Resistance (kilohm)
20 {68}	2.21-2.69
60 {140}	0.493-0.667

Fig 1: Identifying Intake Air Temperature Sensor Connector Terminals

Courtesy of MAZDA MOTORS CORP.