If simulation function of M-MOS is not used:

OPERATION OF FUEL INJECTOR INSPECTION

STEP	INSPECTION		ACTION
1	Perform the KOER self-test function using the M-MDS. (See KOEO/KOER SELF TEST .) Are DTCs P0201, P0202, P0203 and/or P0204 present?	Yes	Go to appropriate DTC test. (See DTC TABLE .)
1		No	Go to the next step.
2	Inspect the fuel injector for each cylinder. Is the fuel injector normal?	Yes	Go to the next step.
2		No	Replace the fuel injector.
3	Inspect the following for the suspected cylinder: Fuel injector power and/or ground system related wiring harnesses and connectors. PCM terminals (pulled-out pins, corrosion) Fuel injector terminals (pulled-out pins, corrosion) Are all items normal?	Yes	Inspect PCM terminal voltage of fuel injector signal
3		No	Repair or replace malfunctioning parts.