Variable Swirl System Operation Inspection: Notes

1. Connect the M-MDS to the DLC-2.
2. Access the ECT PID.
3. Verify that the ECT PID is below 60°C {140°F}. 
4. Start the engine.
5. Inspect the rod operation under the following conditions:

Rod operation

If the rod operation is not specified, inspect as follows: 

1. Perform the KOER self-test using the M-MDS and verify that DTCs No. P2004, P2006, P2009 or P2010 are not displayed.
   • If DTC No. P2004, P2006, P2009 or P2010 are displayed, perform DTC inspection.

     (See DTC TABLE .)