No. 5 Resetting Procedure for the Immobilizer System when Replacing the PCM, Keyless Control Module, or Steering Lock Unit: Condition

When the keyless control module is replaced
- Have one or more card keys to be programmed after the replacement.
- Have two or more keys to be programmed after the replacement.
When the keyless control module is not to be replaced
- Have one or more card keys to be programmed.
- Have two or more keys to be programmed after the replacement.
  CAUTION:
  - Perform the procedures in the following order: "Key ID number clearing", "Card key programming", "Steering lock unit programming", and "Key programming". If there is a failure in the programming, the engine may not be started.
  - When replacing only the PCM, start from Step 2. Key 1 in the procedure can be any valid key.
  - Perform the "card key programming procedure" in Step 9 only when the keyless control module is replaced.
  - Perform the "steering lock unit programming procedure" in Step 10 only when either the keyless control module or steering lock unit is replaced.