LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Security System And Locks System >> Immobilizer System Component Replacement/Key Addition And Clearing [With Advanced Keyless System] >> No. 4 Key Additional Programming Procedure Changing >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

No. 4 Key Additional Programming Procedure Changing: Procedure

  1. Using the key, turn the ignition switch to the ON position. (The key can be either the valid key or an unprogrammed key)
    NOTE:
    • Although the security light flashes and DTC 15 is displayed when an unprogrammed key is used, this does not indicate an improper procedure. Continue to perform the procedure as indicated.
  2. Connect the M-MDS to the DLC-2.
  3. Select "BODY/SECURITY/PATS (immobilizer) function" from the M-MDS screen menu.
  4. Select "Customer spare key programming enable" or "Customer spare key programming disable" from the M-MDS screen menu. The key additional programming procedure is as follows according to the selected menu:
    DIAGNOSTIC PROCEDURE

    Setting Additional key programming procedure
    Method using two valid keys Method using the M-MDS
    Customer spare key programming enable - -
    Customer spare key programming disable x -
    - : Available
    x : Unavailable
  5. Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE ).
  6. After verifying that the PATS function menu is displayed again on the M-MDS screen, select "Finish (this menu)" to finish the M-MDS procedure.
  7. After Step  6, wait 5 s or more  and then turn the ignition switch to the LOCK position.
scientia non olet · About LEMON Manuals