| 1 |
- Close all doors.
- Turn the ignition switch to the ON position.
- In automatic mode, push down the power window main switch for the driver-side front door glass. The door glass should move down within approx. 43 s
after ignition switch off.
- In manual mode (finger continuously depressing the power window main switch), the door glass should move down within approx. 43 s
after ignition switch off.
- Does the driver-side front door glass move down?
|
Yes |
Go to the next step. |
| No |
- Perform the driver-side power window initialization procedure, and reinspect. (See
POWER WINDOW INITIALIZATION PROCEDURE.
)
- If it does not move up and down upon reinspection, inspect the following:
- Wiring harness for the door open/close signal system
- Latch switch
- Repair or replace the malfunctioning part, and reinspect.
- If operation is not normal, replace the power window main switch, and then go to the next step.
|
| 2 |
- Turn the ignition switch to the ON position.
- In automatic mode, pull up the power window main switch for the driver-side front door glass. The door glass does not move up within approx. 43 s
after ignition switch off.
- Verify that driver-side front door glass does not operate.
- Does the driver-side front door glass move up?
|
Yes |
- Perform the driver-side power window Initialization procedure, and reinspect. (See
POWER WINDOW INITIALIZATION PROCEDURE.
)
- If operation is not normal, replace the power window main switch, then go to the next step.
|
| No |
Go to the next step. |
| 3 |
- Turn the ignition switch to the ON position.
- Lower the driver-side front door glass completely.
- Take a hammer and hold it against the inside of the top of the door glass frame so that the door glass will hit its handle when it is closing.
- Raise the door glass using manual mode.
- When the door glass hits the hammer handle, does it immediately reverse and move down to approx. 200 mm {7.87 in}
from the completely closed position?
|
Yes |
Go to the next step. |
| No |
- Perform the driver-side power window initialization procedure, and reinspect. (See
POWER WINDOW INITIALIZATION PROCEDURE.
)
- If operation is not normal, replace the power window main switch, then go to the next step.
|
| 4 |
- Open front door.
- Turn the ignition switch to the ON position.
- Push/pull the power window main switch for the door glass within approx. 43 s
after ignition switch off.
- Verify that the door glass does not move up or down.
- Does the door glass move up or down?
|
Yes |
- Inspect the door switch and related wiring harness.
- If above parts are normal, replace the power window main switch, then go to the next step.
- If the above parts have any malfunction, repair or replace the malfunction part, then go to the next step.
|
| No |
Go to the next step. |
| 5 |
- Close front door.
- Turn the ignition switch to the ON position.
- Push/pull the power window main switch for door glass after approx. 60 s
after ignition switch off.
- Verify that the door glass does not move up or down.
- Does the door glass move up or down?
|
Yes |
- Perform the driver-side power window initialization procedure, and reinspect. (See
POWER WINDOW INITIALIZATION PROCEDURE.
)
- If operation is not normal, replace the power window main switch, then go to the two-step down function inspection.
|
| No |
- The IG OFF timer function is normal.
- Go to the two-step down function inspection.
|