Diagnostic procedure

DTC P2009 DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	VERIFY FREEZE FRAME DATA HAS BEEN RECORDED Has the FREEZE FRAME DATA been recorded?	Yes	Go to the next step.
1		No	Record FREEZE FRAME DATA on the repair order, then go to the next step.
2	VERIFY RELATED REPAIR INFORMATION AVAILABILITY Check for related Service Bulletins and/or online repair information availability. Is any related repair information available?	Yes	Perform the repair or diagnosis according to the available repair information. If the vehicle is not repaired, go to the next step.
2		No	Go to the next step.
3	INSPECT VARIABLE SWIRL SOLENOID VALVE CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Inspect for poor connection (such as damaged/pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair or replace the terminal, then go to Step 9.
3		No	Go to the next step.
4	INSPECT VARIABLE SWIRL SOLENOID VALVE Perform the variable swirl solenoid valve inspection. (See VARIABLE SWIRL SOLENOID VALVE INSPECTION ). Is the variable swirl solenoid valve normal?	Yes	Go to the next step.
4		No	Replace the variable swirl solenoid valve, then go to Step 9.
5	INSPECT VARIABLE SWIRL SOLENOID VALVE POWER SUPPLY CIRCUIT FOR OPEN CIRCUIT Disconnect the variable swirl solenoid valve connector. Turn ignition switch to the ON position (Engine off). Measure voltage between variable swirl solenoid valve terminal A (harness-side) and body ground. Is the voltage B+ ?	Yes	Go to the next step.
5		No	Repair or replace the wiring harness for an open circuit, then go to Step 9.
6	INSPECT PCM CONNECTOR FOR POOR CONNECTION Turn the ignition switch off. Disconnect the PCM connector. Inspect for poor connection at PCM terminal 4K. (such as damaged, pulled-out pins, corrosion). Is there any malfunction?	Yes	Repair terminal, then go to Step 9.
6		No	Go to the next step.
7	INSPECT VARIABLE SWIRL SOLENOID VALVE CONTROL CIRCUIT FOR SHORT TO GROUND Inspect for continuity between variable swirl solenoid valve terminal B (harness-side) and body ground. Is there continuity?	Yes	Repair or replace the wiring harness for a short to ground, then go to Step 9.
7		No	Go to the next step.
8	INSPECT VARIABLE SWIRL SOLENOID VALVE CONTROL CIRCUIT FOR OPEN CIRCUIT Connect variable swirl solenoid valve connector. Turn ignition switch to the ON position (Engine off). Measure the voltage between PCM terminal 4K (harness-side) and body ground. Is the voltage B+ ?	Yes	Go to the next step.
8		No	Repair or replace the wiring harness for an open or short to ground circuit, then go to the next step.
9	VERIFY TROUBLESHOOTING OF DTC P2009 COMPLETED Make sure to reconnect all disconnected connectors. Clear the DTC from the PCM memory using the WDS or equivalent. Turn the ignition switch off. Start the engine and warm it up completely. Is the PENDING CODE for this DTC present?	Yes	Replace the PCM, then go to the next step. (See PCM REMOVAL/INSTALLATION ).
9		No	Go to the next step.
10	VERIFY AFTER REPAIR PROCEDURE Perform the "After Repair Procedure". (See AFTER REPAIR PROCEDURE ). Are any DTCs present?	Yes	Go to the applicable DTC inspection. (See DTC TABLE ).
10		No	Troubleshooting completed.