Flasher Control Module Inspection: Notes
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the flasher control module with the connector still connected.
- Measure the voltage at each terminal (other than terminal F).
- If the voltage is not as specified in TERMINAL VOLTAGE TABLE inspect the parts under "Inspection item(s)".
- Disconnect the flasher control module connector.
- Verify that continuity at terminal F is as indicated in TERMINAL VOLTAGE TABLE
.
- If there is any malfunction, inspect the parts under "Inspection item(s)".
- If the system does not work properly even though the parts or related wiring harnesses do not have any malfunction, replace the flasher control module.
- If there is any malfunction, inspect the parts under "Inspection item(s)".