Accelerator Pedal Position (App) Sensor Inspection: Notes

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before performing the following inspection, make sure to follow the troubleshooting flowchart. (See FOREWORD .)

Connect the M-MDS to the DLC-2.
Turn the ignition switch to ON position.
Select APP1 and APP2 PID on the M-MDS.
Verify that the APP1 and APP2 PID is within the specification when the accelerator pedal not depressed. (See PCM INSPECTION ).

Fig 1: Identifying Data Link Connector 2
Courtesy of MAZDA MOTORS CORP.