Continuity Inspection

WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.

Remove the neutral switch. (See NEUTRAL SWITCH REMOVAL/INSTALLATION .)

Verify that the continuity between neutral switch terminals A and B is as indicated in the table.

If it can be verified, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
If it cannot be verified, replace the neutral switch.

Fig 1: Identifying Neutral Switch Connector Terminals
Courtesy of MAZDA MOTORS CORP.

CONTINUITY REFERENCE

Measured condition	Continuity
Rod pushed	Continuity detected
Except above	No continuity