Solar Radiation Sensor Removal/Installation
WARNING: This page is about a different car, the 2007 Mazda 3. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Pry the solar radiation sensor from the dashboard using a flathead screwdriver wrapped with protective tape.
- Remove in the order indicated in the table.CAUTION:
- After the solar radiation sensor removal, the sensor connector could fall in the dashboard making the installation difficult. Therefore, hold the rooted end of the sensor connector using a clip or similar tool to prevent it from falling.
- Install in the reverse order of removal.