Steering Lock Unit Id Code Registration[Advanced Keyless System]
WARNING: This page is about a different car, the 2007 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed.
- M-MDS
- Personal computer
- Device that can send/receive radio waves
NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION .)
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.
- Bring the programmed card key into the vehicle.
- Fully lower the driver-side door glass.
- Connect the M-MDS to the DLC-2.
- Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.
- After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
- Select "BODY"
- Select "SECURITY"
- When using the PDS (Pocket PC)
- Select "Programming".
- When using the IDS (laptop PC)
- Then, select items from the screen menu in the following order.
- Select "PATS Functions"
- Select "Steering Lock Unit Programming"
- Perform the security access according to the directions on the M-MDS screen. (See SECURITY ACCESS PROCEDURE[ADVANCED KEYLESS SYSTEM] .)
- The security access begins and the M-MDS displays "OUT-CODE".NOTE:
- When "OUT-CODE" is first displayed, turning the ignition switch from the LOCK to the ON position 5 times will change the "OUT-CODE".
- Input the "IN-CODE" that corresponds to the "OUT-CODE" displayed on the M-MDS screen.