Possible Causes

CAUTION:

Use the Flex Probe Kit for all test connections to prevent damage to the wiring terminals. Do not use standard multimeter probes.

IGNITION SWITCH IS INOPERATIVE - PINPOINT TEST REFERENCE

PINPOINT TEST 1		THE IGNITION SWITCH IS INOPERATIVE
STEP	INSPECTION		ACTION
1	CHECK THE VOLTAGE SUPPLY TO THE IGNITION SWITCH Key in OFF position. Disconnect: Ignition switch C-250. Measure the voltage between ground and: ignition switch C-250 pin 2, circuit (R), harness side. ignition switch C-250 pin 7, circuit (R), harness side. ignition switch C-250 pin 9, circuit (R), harness side. Are the voltages greater than 10 volts?	Yes	Install a new ignition switch. See IGNITION SWITCH , . Test the system for normal operation.
1		No	Verify battery junction box (BJB) fuse 9 (40A) is OK. If OK, repair circuit (Y) for an open. Clear the DTCs. Test the system for normal operation.