Cruise Control Switch Removal / Installation

Fig 1: Removing/Installing Cruise Control Switch

Courtesy of MAZDA MOTORS CORP.

1. Remove the steering wheel. See STEERING WHEEL .
2. Remove the two screws and steering wheel rear cover.
3. Remove the ribbon harness from the clips.
4. Remove in order shown in figure.
   NOTE:

   • Install ground eyelet under upper screw on right-hand switch. Position switch(es) on steering wheel and install four Phillips-head attaching screws.
5. Install in reverse order of removal.

Tightening torque: Horn switch screws 

6.5-7.5 N.m {0.66-0.76 kgf.m, 4.8-5.5 ft.lbf}