Keyless Control Module Removal/Installation[Advanced Keyless System]
NOTE:
- If the keyless control module is replaced, always perform the following procedure.
Without immobilizer system
- Card key programming (See CLEARING CARD KEY[ADVANCED KEYLESS SYSTEM] .)
- Steering lock unit programming (See STEERING LOCK UNIT ID CODE REGISTRATION[ADVANCED KEYLESS SYSTEM] .)
With immobilizer system
- Card key programming (See CLEARING CARD KEY[ADVANCED KEYLESS SYSTEM] .)
- Steering lock unit programming (See STEERING LOCK UNIT ID CODE REGISTRATION[ADVANCED KEYLESS SYSTEM] .)
- Immobilizer system resetting (with immobilizer system) (See IMMOBILIZER SYSTEM COMPONENT REPLACEMENT/KEY ADDITION AND CLEARING[ADVANCED KEYLESS SYSTEM] .)
- Disconnect the negative battery cable.
- Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
- Disconnect the keyless control module connector.
- Remove the bolt, then remove the keyless control module.
- Install in the reverse order of removal. BOLT