LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> CX-9 Sport, 3.5 Y, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System/Roll Stability Control System >> DSC/RSC Sensor Initialization Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DSC/RSC Sensor Initialization Procedure

WARNING:
  • Unless the initialization procedure of the combined sensor is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC/RSC operation if the combined sensor and DSC/RSC HU/CM have been removed or replaced.
  1. Inspect the wheel alignment and inflation pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Park the vehicle on level ground.
  3. Turn the ignition switch off.
  4. Connect the M-MDS to the DLC-2 connector.
  5. After the vehicle is identified, select the following items from the initial screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select the "Toolbox" tab.
      2. Select "Chassis".
      3. Select "ABS/DSC".
      4. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "Module Test".
      2. Select "ABS".
      3. Select "Datalogger".
      4. Select "SSRJNTL".
  6. Perform the initialization according to the directions on the screen.
Fig 1: Identifying DLC2 Connector Terminal
G04969748Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals