LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> CX-9 Sport, 3.5 Y, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System/Roll Stability Control System >> Front Abs Wheel-Speed Sensor Inspection >> Sensor Output Value Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Sensor Output Value Inspection

  1. Turn the ignition switch off.
  2. Connect the M-MDS to the DLC-2 connector.
  3. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
    1. Select the "Toolbox" tab.
    2. Select "DataLogger".
    3. Select "Module".
    4. Select "ABS".
    • When using the PDS (Pocket PC)
    1. Select "Module Tests".
    2. Select "ABS".
    3. Select "DataLogger".
  4. Select the following PIDs using the M-MDS:
    • WSPDJ_F

      (LF ABS wheel-speed sensor)

    • WSPD_RF

      (RF ABS wheel-speed sensor)

  5. Start the engine and drive the vehicle.
  6. Verify that the display of the M-MDS shows the same value as the speedometer.
Fig 1: Identifying DLC2 Connector
G04969748Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals