On-Board System Readiness Tests Access Procedure

Connect the M-MDS to DLC-2

Fig 1: Locating DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select the "Toolbox"tab.
  2. Select "Self Test".
  3. Select "Modules".
  4. Select "PCM".
- When using the PDS (Pocket PC)
  1. Select "Module Tests".
  2. Select "PCM".
  3. Select "Self Test".
Then, select the "***SUP" and "***EVAL" PIDs in the PID selection screen.
Monitor those PIDs and check the system monitor is completed.