Input/Turbine Speed Sensor Removal/Installation

INPUT/TURBINE SPEED SENSOR REMOVAL/INSTALLATION [FS5A-EL]
1. Remove the battery cover.
2. Disconnect the negative battery cable.
3. Remove the battery duct.
4. Remove the battery, battery box and battery tray.
5. Remove the air cleaner component.





6. Disconnect the input/turbine speed sensor connector.
7. Remove the input/turbine speed sensor.
8. Apply ATF to a new O-ring and install it on input/ turbine speed sensor.
9. Install the input/turbine speed sensor.
Tightening torque 8-11 N-m (82-112 kgf-cm, 71-97 in-lbf)
10. Connect the input/turbine speed sensor connector.
11. Install the air cleaner component.
12. Install the battery, battery box and battery tray.
13. Install the battery duct.
14. Connect the negative battery cable.
15. Install the battery cover.