Normal Operation: Notes

Under normal operation, the exterior mirror control switch uses circuit (GY) as the common circuit for both exterior mirror up/down and right/left movement.

This pinpoint test is intended to diagnose the following:

Wiring, terminals or connectors
Exterior mirror control switch
Exterior mirror motor
Exterior mirror

MIRRORS INOPERATIVE - PINPOINT TEST 2

PINPOINT TEST 2		A SINGLE MIRROR IS INOPERATIVE
STEP	INSPECTION		ACTION
1	CHECK THE LH AND RH EXTERIOR MIRRORS Operate the LH and RH exterior mirrors to the up, down, left and right positions. Does the LH exterior mirror operate correctly?	Yes	Go to next step.
1		No	Go to step 4.
2	CHECK THE EXTERIOR MIRROR CONTROL SWITCH Disconnect: Exterior Mirror Control Switch connector 0912-301. Carry out the Exterior Mirror Control Switch Component Test. See table at the end of this pinpoint test. Did the exterior mirror control switch pass the component test?	Yes	Go to next step.
2		No	INSTALL a new exterior mirror control switch. See EXTERIOR MIRROR CONTROL SWITCH . TEST the system for normal operation.
3	CHECK CIRCUIT (GY) FOR AN OPEN Key in OFF position. Disconnect: RH Exterior Mirror connector 0912-303. Measure the resistance between exterior mirror control switch, 0912-301 pin 6, (GY) harness side and RH exterior mirror, 0912-303, pin 2 (GY) harness side. Is the resistance less than 5 ohms?	Yes	CHECK the RH exterior mirror jumper harness between the vehicle harness and the exterior mirror motor for open circuits and damaged or pushed-out pins. If the jumper harness is not OK, REPAIR the jumper harness. If the jumper harness cannot be repaired, INSTALL a new exterior mirror. See EXTERIOR MIRROR . If the jumper harness is OK, INSTALL a new exterior mirror motor. See EXTERIOR MIRROR COVER . TEST the system for normal operation.
3		No	REPAIR the circuit. TEST the system for normal operation.
4	CHECK THE EXTERIOR MIRROR CONTROL SWITCH Disconnect: Exterior Mirror Control Switch connector 0912-301. Carry out the Exterior Mirror Control Switch Component Test. See table at the end of this pinpoint test. Did the exterior mirror control switch pass the component test?	Yes	Go to next step.
4		No	INSTALL a new exterior mirror control switch. See EXTERIOR MIRROR CONTROL SWITCH . TEST the system for normal operation.
5	CHECK CIRCUIT (GY) FOR AN OPEN Disconnect: LH Exterior Mirror connector 0912-302. Measure the resistance between exterior mirror control switch 0912-301 pin 6, circuit (GY), and LH exterior mirror 0912-302 pin 2, circuit (GY). Is the resistance less than 5 ohms?	Yes	CHECK the LH exterior mirror jumper harness between the vehicle harness and the exterior mirror motor for open circuits and damaged or pushed-out pins. If the jumper harness is not OK, REPAIR the jumper harness. If the jumper harness cannot be repaired, INSTALL a new exterior mirror. See EXTERIOR MIRROR . If the jumper harness is OK, INSTALL a new exterior mirror motor. See EXTERIOR MIRROR COVER . TEST the system for normal operation.
5		No	REPAIR the circuit. TEST the system for normal operation.