Fuel Injector Removal/Installation[L3 With TC]: Notes

CAUTION:

Disconnecting/connecting the quick release connector without cleaning it may cause damage to the fuel pipe and quick release connector. Always clean the quick release connector joint area before disconnecting/connecting using a cloth or soft brush, and make sure that it is free of foreign material.

NOTE:

When the fuel pressure sensor replaces, replace a new fuel delivery pipe with a new fuel pressure sensor.(See FUEL INJECTOR REMOVAL/INSTALLATION[L3 WITH TC] )

Complete the "BEFORE REPAIR PROCEDURE". (See BEFORE REPAIR PROCEDURE[L3 WITH TC] .)
Disconnect the negative battery cable.
Remove the intake manifold. (See INTAKE AIR SYSTEM REMOVAL/INSTALLATION[L3 WITH TC] ).
Remove in the order indicated in the table.

Fig 1: Fuel Injector Replacement Components With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.
Complete the "AFTER REPAIR PROCEDURE". (See AFTER REPAIR PROCEDURE[L3 WITH TC] .)