Powertrain Control Module (Pcm) - 3.0L (4V) Removal/Installation: Installation
- Install the PCM and the 2 stud bolts.
- To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
- Connect the 3 PCM electrical connectors.
- Position the manifold absolute pressure (MAP) sensor and the wiring harness and install the 2 PCM stud bolt nuts.
- To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. See PROGRAMMABLE MODULE INSTALLATION .
- Reprogram the passive anti-theft system (PATS). Carry out the Key Programming Using Two Programmed Keys procedure. See KEY PROGRAMMING USING TWO PROGRAMMED KEYS .