Power Window Motor Removal/Installation
- Fully lower the rear door glass.
- Disconnect the negative battery cable.
- Remove the following parts:
Front door
- Inner garnish (See INNER GARNISH REMOVAL/INSTALLATION )
- Front door trim (See FRONT DOOR TRIM REMOVAL/INSTALLATION )
Rear door
- Sail garnish (See SAIL GARNISH REMOVAL/INSTALLATION )
- Rear door trim (See REAR DOOR TRIM REMOVAL/INSTALLATION )
- Remove the bolts.
- Remove the power window motor from the power window regulator.
- Disconnect the power window motor connector.
- Install in the reverse order of removal.NOTE:
- When installing the power window motor to the power window regulator drum, the drum housing tabs may detach from the door module. If this happens, insert a hand through the speaker installation hole to engage the drum housing tabs, and install the power window motor to the drum while supporting the drum housing.