LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2009 >> CX-9 Touring, 3.7 V, AWD >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System/Roll Stability Control System >> DSC/RSC Sensor Initialization Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DSC/RSC Sensor Initialization Procedure

WARNING:
  • Unless the initialization procedure of the combined sensor is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC/RSC operation if the combined sensor and DSC/RSC HU/CM have been removed or replaced. 
  1. Inspect the wheel alignment and inflation pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Park the vehicle on level ground.
  3. Turn the ignition switch off.
  4. Connect the M-MDS to the DLC-2.
  5. After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
    • When using the IDS (laptop PC)
      1. Select "Chassis".
      2. Select "ABS/DSC".
      3. Select "Sensor Initialization".
    • When using the PDS (Pocket PC)
      1. Select "Module Test".
      2. Select "ABS".
      3. Select "Datalogger".
      4. Select "SSR_INTL".
  6. Perform the initialization according to the directions on the screen.
    Fig 1: Identifying DLC2 Connector Terminal
    G04969748Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals