Powertrain Control Module (Pcm) Removal/Installation - 2.5L: Installation
- Install the PCM cowl seal.
- Install the PCM and the 2 bolts.
- Tighten to 6 N.m {0.6 kgf.m, 53 in.lbf}.
- Connect the 3 PCM electrical connectors.
- Attach the wiring harness retainer to the cowl stud bolt.
- Tighten to 6 N.m {0.6 kgf.m, 53 in.lbf}.
- Restore the module configuration. Carry out the module configuration restore steps of the Programmable Module Installation procedure. See PROGRAMMABLE MODULE INSTALLATION (PMI) .
- Reprogram the passive anti-theft system (PATS). Carry out the Parameter Reset procedure. See KEY PROGRAMMING USING TWO PROGRAMMED KEYS .
- Using the scan tool, perform the Misfire Monitor Neutral Profile Correction procedure, following the on-screen instructions.