DTC P0602: Notes
DTC P0602 [L3] DETECTION CONDITIONS AND POSSIBLE CAUSES
| DTC P0602 |
PCM programming error |
| DETECTION CONDITION |
- No configuration data in the PCM
NOTE:
- If the "PCM CONFIGURATION" is successful, the PCM stores DTC P0602 and illuminates the MIL (system is normal). Clear DTC P0602 using the M-MDS after the "PCM CONFIGURATION".
- The MIL goes out after three drive cycles with no failure (DTCs remain in PCM).
Diagnostic support note
- This is a continuous monitor (CCM).
- MIL illuminates if the PCM detects the above malfunction condition in the first drive cycle.
- FREEZE FRAME DATA (Mode 2/Mode12) is available.
- The DTC is stored in the PCM memory.
|
| POSSIBLE CAUSE |
- Configuration has not been completed
- PCM malfunction
|