Front Toe Adjustment

Start the engine and center the steering wheel.
Turn the engine off. Hold the steering wheel in the straight-ahead position using a suitable holding device.
Check the toe settings following the equipment manufacturer's instructions.
Remove the steering gear bellows clamp(s).
NOTE:
- Do not allow the steering gear bellows to twist when the front wheel spindle tie-rod is rotated.
  
  Fig 1: Locating Steering Gear Bellows Clamp
  Courtesy of MAZDA MOTORS CORP.
Loosen the tie-rod end jam nut(s).
- Clean and lubricate the nut(s) and front wheel spindle tie-rod threads.
  
  Fig 2: Locating Tie-Rod End Jam Nut
  Courtesy of MAZDA MOTORS CORP.
Rotate the front wheel spindle tie-rods to increase or decrease the front toe.

Fig 3: Rotating Front Wheel Spindle Tie-Rods To Increase And Decrease Front Toe
Courtesy of MAZDA MOTORS CORP.
Tighten the tie-rod end jam nut(s) to 40 N.m {4.0 kgf.m, 30 ft.lbf}.
CAUTION:
- Hold the tie-rod end stationary with a wrench while tightening the nut, or damage to the boot can occur.
NOTE:
- Do not disturb the toe settings while tightening the nut(s).
  
  Fig 4: Locating Tie-Rod End Jam Nut
  Courtesy of MAZDA MOTORS CORP.
Install the steering gear bellows clamp(s).

Fig 5: Locating Steering Gear Bellows Clamp
Courtesy of MAZDA MOTORS CORP.
Check the toe settings. Follow the equipment manufacturer's instructions.