LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2011 >> 3 i Touring, 2.0 F, Automatic >> Repair and Diagnosis >> Restraints >> Restraints Control Systems >> Seat Belt System >> Buckle Switch Inspection >> Driver Side
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Driver Side

  1. Switch the ignition to off.
  2. Disconnect the negative battery cable.
  3. Remove the front seat. (See FRONT SEAT REMOVAL/INSTALLATION ).
  4. Remove the front buckle. (See FRONT BUCKLE REMOVAL/INSTALLATION ).
  5. Inspect for continuity between the buckle switch terminals using a tester.
    • If not as indicated in the table, replace the driver side front buckle.
      Fig 1: Inspecting Continuity Between Buckle Switch Terminals Using Tester
      G07626715Courtesy of MAZDA MOTORS CORP.
      Fig 2: Identifying Power Seat And Without Power Seat Switch
      G06731718Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals