DSC/RSC Sensor Initialization Procedure
WARNING:
- Unless the initialization procedure of the DSC/RSC HU/CM is completed, the DSC/RSC will not operate, causing an unexpected accident. Therefore, always perform the initialization procedure to ensure DSC/RSC operation if the DSC/RSC HU/CM or SAS control module have been removed or replaced.
- Inspect the wheel alignment and inflation pressure.
- If there is any malfunction, adjust the applicable part.
- Park the vehicle on level ground.
- Turn the ignition switch to the LOCK position.
- Connect the M-MDS to the DLC-2.
- After the vehicle is identified, select the following items from the initialization screen of the IDS.
- Select "Chassis".
- Select "ABS/DSC".
- Select "Sensor Initialization".
- Perform the initialization according to the directions on the screen.