DSC Control Inspection
- Perform "Preparation".
- Connect the M-MDS to the DLC-2.
Courtesy of MAZDA MOTORS CORP.
- Set up an active command mode inspection according to the combination of commands below.
CAUTION:
- To protect the DSC/RSC HU/CM, the solenoid valve and the pump motor used during active command mode stay on for only 10 s or less each time they are switched on.
WHEELS INSPECTION CHART
| Command name |
Inspected wheels |
| Understeer control inhibited |
Oversteer control inhibited |
| LF |
RF |
LR |
RR |
| V_TRC_L |
ON |
OFF |
ON |
| V_TRC_R |
OFF |
ON |
OFF |
| V_STB_L |
OFF |
| V_STB_R |
| V_LF_INL |
OFF |
OFF |
OFF |
ON |
| V_LF_OTL |
OFF |
| V_LR_INL |
ON |
| V_LR_OTL |
OFF |
| V_RF_INL |
ON |
| V_RF_OTL |
OFF |
| V_RR_INL |
ON |
| V_RR_OTL |
OFF |
| PMP_MOTOR |
ON |
- Send the command while rotating the wheel being inspected by hand in a forward direction.
- Confirm that the wheel does not rotate easily while a DSC/RSC HU/CM operation click sound is heard.
- Performing the inspection above determines the following:
- The DSC/RSC HU/CM brake lines are normal.
- The DSC/RSC HU/CM hydraulic system is not significantly abnormal (including DSC/RSC HU/CM).
- The DSC/RSC HU/CM internal electrical parts (solenoid, motor and other parts) are normal.
- The DSC/RSC unit and DSC/RSC HU/CM output system wiring harnesses (solenoid valve, relay system) are normal.
- However, the following items cannot be verified.
- Malfunction with intermittent occurrence of the above items
- Malfunction of DSC/RSC HU/CM input system wiring harnesses and parts
- Extremely small leaks in the DSC/RSC HU/CM internal hydraulic system