DTC P0500:00: Notes

DTC P0500:00	VSS circuit problem
DETECTION CONDITION	If an error in the wheel speed signal from the DSC HU/CM is detected by CAN when the following conditions are met: Neutral switch and CPP switch: OFF (MTX) Shift range: except P, N or R position (ATX) Load: above 40 % Engine speed: 2,000 rpm or above Brake switch: OFF Diagnostic support note This is a continuous monitor (CCM). The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM. PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle. FREEZE FRAME DATA (Mode 2)/Snapshot data is available. The DTC is stored in the PCM memory.
POSSIBLE CAUSE	DSC HU/CM DTC is stored. DSC HU/CM connector or terminals malfunction Front ABS wheel-speed sensor malfunction DSC HU/CM malfunction PCM connector or terminals malfunction PCM malfunction

DTC P0500:00

VSS circuit problem

DETECTION CONDITION

If an error in the wheel speed signal from the DSC HU/CM is detected by CAN when the following conditions are met:
- Neutral switch and CPP switch: OFF (MTX)
- Shift range: except P, N or R position (ATX)
- Load: above 40 %
- Engine speed: 2,000 rpm or above
- Brake switch: OFF
Diagnostic support note
This is a continuous monitor (CCM).
The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
PENDING CODE is available if the PCM detects the above malfunction condition during first drive cycle.
FREEZE FRAME DATA (Mode 2)/Snapshot data is available.
The DTC is stored in the PCM memory.

POSSIBLE CAUSE

DSC HU/CM DTC is stored.
- DSC HU/CM connector or terminals malfunction
- Front ABS wheel-speed sensor malfunction
- DSC HU/CM malfunction
PCM connector or terminals malfunction
PCM malfunction