Without auto-open/close function

Disconnect the negative battery cable.
Remove the inner garnish. (See INNER GARNISH REMOVAL/INSTALLATION .)
Remove the front door trim. (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
Verify that the continuity is as indicated in the table using a tester.

Fig 1: Identifying Power Window Subswitch Harness-Side Connector (Without Auto-Open/Close Function)
- If not as indicated in the table, replace the power window subswitch. (See POWER WINDOW SUBSWITCH REMOVAL/INSTALLATION .)
  
  Fig 2: Power Window Subswitch Terminals Continuity Chart