Steering Lock Unit Id Code Registration [Advanced Keyless Entry And Push Button Start System]
CAUTION:
- Do not place the following devices in the vehicle while programming, otherwise programming cannot be performed:
- M-MDS
- Personal computer
- Devices that can send/receive radio waves
NOTE:
- The steering lock unit and steering lock component are a single unit. Therefore, replace the steering lock component when replacing steering lock unit. (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITHOUT ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] ) (See STEERING WHEEL AND COLUMN REMOVAL/INSTALLATION [WITH ADVANCED KEYLESS ENTRY AND PUSH BUTTON START SYSTEM] )
- For this procedure, a programmed card key is necessary. If there is no programmed card key, perform the steering lock unit programming after the card key programming.
- Bring the programmed advanced key into the vehicle.
- Fully lower the driver-side door glass.
- Connect the M-MDS (IDS) to the DLC-2.
- Pull out the M-MDS cable from the door glass opening and set the M-MDS outside the vehicle.CAUTION:
- Cover the vehicle body with a clean rag so as not to damage the vehicle body with the cable.
- After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
- Select the "Body"
- Select the "Security"
- Select the "PATS Functions"
- When using the IDS (laptop PC)
- Then, select an items from the screen menu.
item
- Steering Lock Unit Programming
- Perform the security access according to the directions on the M-MDS screen.