Power Window Main Switch Inspection: Notes
WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
- Switch the ignition to ON.
- Verify that the door glass (driver's side) can be operated for approx. 43 s
after the ignition is switched off.
- If the door glass (driver's side) cannot be operated for approx. 43 s after the ignition is switched off, or if the door glass (driver's side) can still be operated after approx. 43 s, replace the power window main switch.
- Disconnect the negative battery cable
- Remove the inner garnish (driver's side) (See INNER GARNISH REMOVAL/INSTALLATION .)
- Remove the front door trim (driver's side) (See FRONT DOOR TRIM REMOVAL/INSTALLATION .)
- Remove the main switch panel (driver's side) (See FRONT DOOR TRIM DISASSEMBLY/ASSEMBLY .)
- Connect the power window main switch connector
- Connect the negative battery cable.
- Measure the voltage at each terminal.
- If the voltage is not as specified in the terminal voltage table, inspect the parts under inspection item (s) and related wiring harnesses.
- If the system does not work normally even though the inspection items or related wiring harnesses do not have any malfunction, replace the power window main switch