Auto Light/Wiper Control Module Configuration

WARNING: This page is about a different car, the 2009 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Use the IDS (laptop PC) because the PDS (Pocket PC) does not support the AUTO LIGHT/WIPER CONTROL MODULE CONFIGURATION

Connect the M-MDS to the DLC-2

Fig 1: Identifying DLC-2

Courtesy of MAZDA MOTORS CORP.

After the vehicle is identified, select the following items from the initialization screen of the M-MDS.
- When using the IDS (laptop PC)
  1. Select "Module Programming".
Then, select items from the screen menu in the following order
1. Select "Programmable Module Installation"
2. Select "LCM"
Perform the configuration according to the directions on the screen
Retrieve DTCs by the M-MDS, then verify that there is no DTC present
- If a DTC (s) is detected, perform the applicable DTC inspection (See DTC INSPECTION [AUTO LIGHT/WIPER CONTROL MODULE] .)